help, Iphone 4.02.13G baseband and V111...

**macballs** · 11-26-2007, 05:29 PM

How do i make it work and working at V112? any advice appreciated....

I tried updating it from 111 using oktoprep then Itunes to V112, then jaibreak.jar, then when unlocking it using asnysim121u, the phone just freezes and now the phone, I cannot make it to work at V112 or even 111.... Thanks for helping..

**Sponsor** · 11-26-2007 05:29 PM

**DarkCast** · 11-26-2007, 05:45 PM

Did you turn on Airplane Mode in 1.1.2 when you ran AnySIM 1.2.1u? You should. Anyway, you could re-try by logging into your iPhone via SSH. Then issue the commands

launchctl load -w /System/Library/LaunchDaemons/com.apple.CommCenter.plist
reboot

When you get back to the SpringBoard, enable Airplane Mode then run AnySIM 1.2.1u.

Originally Posted by macballs

How do i make it work and working at V112? any advice appreciated....

I tried updating it from 111 using oktoprep then Itunes to V112, then jaibreak.jar, then when unlocking it using asnysim121u, the phone just freezes and now the phone, I cannot make it to work at V112 or even 111.... Thanks for helping..

**macballs** · 11-26-2007, 07:57 PM

No i did not turn airplane ON..... but my problem now I cannot ssh into the phone cause its still not actibvated, not jailbroken... So is there a way i can do what you told me to SSH at this point in time? Many Thanks...

**macballs** · 11-26-2007, 09:01 PM

Will try the solution posted in TUAW again tomorrow.. Thanks DC for advise...

**DarkCast** · 11-26-2007, 09:03 PM

Not yet jailbroken? Not yet activated? I don't think so. How were you able to install and run anyAIM 1.2.1u if the phone's not yet jaibroken and not activated? If you didn't install SSH during the jailbreak, then your best bet is to restore to 1.1.1 and start all over again.